Enter a length and process your part... It’s just that simple!

The TigerStop automatic stop/gauge and pusher system is the perfect addition to almost any machine tool in your shop where ease of setup, ease of use, and accuracy are required. No more battle of the tape measures—every part’s the same with a TigerStop linear measuring system. Employees can be trained in a matter of minutes and be top performers by the end of the day.

Easily installed on most machine tools.

TigerStop provides a cost effective solution for any machine requiring multiple stop positioning. The TigerStop easily converts any manual stop system to a programmable system in just a few hours. A key pad control allows operators to conveniently enter any length in inches, fractional inches, decimal inches or metrics and immediately send pusher/stop to position. The TigerStop can remember up to 99 common lengths for the “Hot Key” inputs. The TigerStop can be used for push feeding of repeated lengths and saw kerf allowance provides for multiple cuts to precise lengths. The memory can be used to store up to 500 lengths as a set point stop system and the built in calculator provides value based cutting positions at the touch of the key pad. The DC Servo encoder is accurate to .004” and the pusher foot is driven by a timing belt. The stop system is available in lengths of 8’; 10’; 12’; 16’; 18’; 20’, 24’ and 30’. TigerStop automates any machine operation which requires multiple stop positions.

Specifications:           

•              Motor:                   DC full loop servo with optical encoder

•              Drive:                     32mm Timing belt, steel reinforced

•              Speed:                   Up to 180 fpm

•              Accuracy:              +/- .004” positioning

•              Display:                  1X16 LCD

TigerStop - automated material pusher and stop

Get More Information